Reduce fuel consumption and run smoother, drier and faster with LencoElectric Trim Tabs.Lenco Trim Tabs owe their success to quality stainless steel components and a powerful, electrically-driven, ball screw actuator design. Standard-Mount Trim Tab blades are 12-gauge, 304 stainlesssteel with a 5/8" flared trailing edge and 1/8" diameter hinge pin. Kit includesstandard actuators with 5/16" stainless steel bolts. Switch Kit sold separately. A minimum transom height of 14" is required for installation.About the actuatorsLenco electric actuators are built around a proven-dependable ball screw design that is twice as powerful as comparable hydraulic models. More power is complemented by an instant response to helm commands, which means you can correct your boat's trim angle much faster than with hydraulic designs. Actuators are (of course) fully submirsible, with a sealed design and "plug and play" waterproof Deutsch connections, which also help to make installation easy.Key FeaturesMore powerful than hydraulic trim tabsInstantly respond to helm commandsTab blades made of corrosion resistant 304 stainless steelWaterproof "plug and play" Deutsch connections facilitate installationAll stainless steel hardwareKit ContentsTwo 12-gauge stainless steel trim tab bladesTwo #15054-001 actuators with 6' leads and Deutsch plugsTwo #30133-103 20' actuator extension wiring harnessesTwo #15085-001 upper mounting brackets with gland sealTwo #50014-001 lower mounting bracketsLenco Owners /Installation manualAll necessary stainless steel mounting hardware